Cepheus Amp Overdrive PCB - Cornish CC-1

Cepheus - Cornish CC-1 Guitar Pedal PCB

$12.00

Available

Not sure where to start? Check our Resources section for more information on building your own guitar pedals.

Back to top

Project overview

The Cepheus Amp Overdrive is adapted from the Pete Cornish CC-1, traced by Aion FX in 2020.

Cornish pedals are best known for being extremely expensive. There are two reasons for this. First, the build quality and reliability is unmatched. Second, the mysterious nature of them, partially due to the fact that the circuit is obscured and partially because of the A-list of clients such as David Gilmour, Brian May and Pete Townshend.

Like the OC-1 Optical Compressor, the CC-1 is a fully original circuit that’s not based on anything else. It’s designed primarily with op-amps, beginning with two feedback clipping stages, each with resistors in series with the diodes to soften the effect. The two-stage stacked clipping gives a very amp-like feel that responds naturally to playing dynamics or increased input signal levels.

After the clipping section, there’s a three-band active tone control adapted from manufacturer application notes (see figure 7 on this page), essentially a Baxandall with an extra band for midrange. There is also a gain boost so the output level can be compensated if the tone controls are cut.

The Cepheus is a faithful reproduction of the CC-1 circuit, but with one major addition: an internal slide switch allowing the pedal to be used in true-bypass mode instead of buffered bypass. As with the Klon KTR, the buffered mode is “almost always better”, but with this feature, you can determine for yourself.