EHX Op-Amp Big Muff Pi - Aion Corvus Fuzz

Corvus - EHX Big Muff, Op-Amp Version Guitar Pedal PCB

$8.00

Available

Not sure where to start? Check our Resources section for more information on building your own guitar pedals.

Back to top

Project description

The Corvus Fuzz is a clone of the 1977-1980 “op-amp” EHX Big Muff Pi. It features the Tone Bypass switch from the second revision, and it has the option to use a modified tonestack as suggested by Analogguru on the Freestompboxes.org forum.

Back to top

Circuit history

The op-amp Big Muff Pi is a complete redesign of the classic Big Muff Pi circuit that uses op-amps instead of discrete transistors. It was designed by Howard Davids and Michael Abrams. While the sound and overall design concept is similar, it’s by no means a replacement for the original, even though at the time it was released it was the only version that was available in stores.

The op-amp version is considered to be the fourth version of the Big Muff. It’s been described as having a harder edge, more of a “grinding” sound than the original which is smoother. It’s most well-known as the pedal behind the guitar tone on Smashing Pumpkins’ 1993 album Siamese Dream.

There were actually two versions of the op-amp Big Muff Pi. The version from 1977 into early 1978 (version 4) had three knobs just like the original. In 1978, they revised the circuit to have a “Tone Bypass” switch which, when engaged, disables the Tone knob and routes the signal around it, causing the output to increase and making the tone even more “in your face”. The tone bypass version is considered Version 5.

In 1979, Electro-Harmonix reintroduced the classic transistor version of the Big Muff Pi but with the addition of the tone bypass switch from Version 5. This is considered to be Version 6 and was the last version of the Big Muff Pi to be released before Electro-Harmonix filed for bankruptcy in 1982 and again in 1984. The Big Muff would not be produced again until 1990 when they began production in Russia.

Back to top

Deluxe Big Muff Pi

The Deluxe Big Muff Pi was a very interesting circuit that combined the op-amp Big Muff Pi with the Soul Preacher compressor and allowed them to be run in parallel and blended together. Since the envelopes are similar (the Soul Preacher being a “clean sustainer”), they paired very well.

There were two versions of the Deluxe Big Muff Pi. The first version, labeled EH-3053 on the schematics and PCB, had a “Blend On/Off” switch allowing you to bypass the Soul Preacher portion of the circuit. With this switch off, it was essentially a ’77 Big Muff Pi, but using a +/-5V bipolar circuit rather than a standard 9V, with parts changed to match. The second version, labeled EH-3054, replaced the Blend switch with a Parallel/Series switch allowing you to either use the two circuits in blend mode (like the previous version) or with the Soul Preacher going into the Big Muff.

The Soul Preacher portion of the circuit was also different between the two versions, with the “Blend On/Off” (3053) version using a near-direct copy of the actual Soul Preacher with discrete transistors, and the “Parallel/Series” (3054) version being a functionally-similar redesign using the CA3080 chip. The first version is widely considered to be the better of the two. The CA3080 variant of the Soul Preacher was never released on its own and was only used as a sub-part of the 3054 circuit.